
You will need:
1. Eggs - real ones emptied out or wooden ones .
2. A lightweight, clear-drying glue made for working with paper. My favorite glue for this project is either PVA which dries very quickly or a more manageable product like Mod Podge or other decoupage glue/sealer. The finish is up to you. I personally prefer the satin lustre look more than the matte or high gloss. 3. Glue brushes - foam or bristle (don't use your really good ones!) 4. An assortment of washi papers. 5. Paper crafting scissors. 6. Some damp paper towels for keeping your hands unglued! 7. Newspapers or disposable cloths to work on.
If you are using wooden eggs, they are likely to be the same size. If you have eggs that vary in size you will need to make the following template for each size. Cut a trial strip from a piece of scrap paper, making it long enough to wrap around the largest part of the egg and create a small overlapping seam. Holding the test strip on one egg, gently press the paper toward the top (narrow) end of the egg, noting where the paper touches the tip of the egg. Mark that spot and repeat the same process at the bottom (wide) end of the egg. Leave a very tiny margin to allow for overlap at both ends. (You'll figure out what you need after you do your first one!) Cut your strip and use it as a guide to cut your washi papers.
Cut one strip of washi, fold it lengthwise, and start cutting strips from the outside edges in toward the folded edge, stopping about 1/2 inch from the fold. The strips should be about 1/4" wide. Trim the ends of the strips into points so they look like the pickets in a picket fence. It is now ready to go on the egg. Some people put their glue on the egg - some people put it on the washi. I've found that I like to limit the amount of gooey glue just waiting for me to get it all over everything, so I start by brushing a band of glue around the middle of the egg, and then fit the washi strip around the egg, onto the glue, and overlap the seam. The overlap should be big enough to hold the paper in place with no empty spot, but not add a lot of extra paper. Then I add glue to one end at a time, usually starting with the small end of the egg and covering all the surface from the center to the tip. You may find you need to add glue as you work. Don't be afraid to use it liberally. It dries clear, and the washi will be molded into the glue! You will also be sealing the egg with the glue when finished, so stray glue on your paper will not matter. Fold the cut strips toward the tip of the egg, pressing the paper into the glue in the center to smooth the area where the strips join the uncut center and move out from there. It's easier to cover the tip smoothly if you first attach three or four strips, skipping some strips as you go. You can then trim the remaining ones to fit, removing extra paper, until all the points touch and cover the tip of the egg. Washi is very forgiving and workable. If you cut too much, patch it! If you end up with a hole, cover it. Smooth it all over with enough glue to make it flat. Pay attention to what you have done so you can adjust your cuts the next time. Repeat with the bottom end of the egg. The spacing is different, but the process is the same. Make the strips longer or shorter as needed when smoothing them down. Don't worry if it still looks a little rough. When you have finished your egg, put it aside to let the glue dry while you work on the next one.
The final step is to add a coat of sealer or finish to the egg. This step is optional, really, but the sealer will protect your egg, give it a look of lacquer, and help to smooth all those edges you were worried about. You can use the same glue you have been working with as long as it dries clear. I like to have a soft look to my finished eggs, so I avoid a glossy product. Other people like the high gloss. They are YOUR eggs! Have them the way you like them. With your brush, paint the glue over the outside of the egg, pressing any edges down as you go. I usually paint about one-half of an egg at a time - then rest the wet egg upright in a small container. Paint the other end when the first one is dry. I like to cut the bottoms out of very small plastic cups, turn them upside down, and make small pedestals for several eggs to dry at one time. You can have eggs drying while you are still working on new ones. You can always start with a few - or go for dozens. Think big! As long as you and your kitchen and maybe the dog and cat are covered in newspapers and glue, you might as well make it worthwhile. You will always find someone who wants them, and you will always want more to add to your own collection. Bonnie
You can play around with these and try your own modifications--for example start with a cheap solid paper base on the egg and add bits and pieces of washi scraps in a crazy quilt fashion (aha! I knew I would think of something for those leftover triangles!). And of course you can try papers other than washi or even start with a plain paper, stamp it out with your own favorite stamps (small is good) and then apply to the eggs--but be sure it is a soft paper rather than stiff. I'd love to see what any of you do with this!
Candice
No comments:
Post a Comment